DOD SR400D Especificações descarregar pdf (Página 151)

143

 3. Check the engine oil level using the dipstick,

located at the rear of the engine, near the top. Add

30W oil, as needed.

 4. Check the blower oil level. Plug is located on the

left side closest to the drain plug. Fill through the

breather plug on the top, until the oil reaches the

bottom of the overflow outlet. (Do not remove the

upper plug on the side near the breather plug.)

Add 40W non-detergent oil, as needed.

 5. Periodically, grease the two fittings, located behind

the blower and above the driver shaft. Regular

chassis grease can be used.

 6. Check the battery fluid level. Add water to cover

the cells, continuing to fill to a level where the fluid

reaches the plastic at the opening.

 7. Ensure battery cables are clean and tightly

connected.

 8. Check the flushing solution level in the one-gallon

tank, located on the right side of the battery. Fill as

needed.

 9. Open the air vent, located on top of the fuel tank

near the gas gauge.

 10. Close the choke, located under the engine air filter,

by pulling out the knob. (Omit this step if the

engine is already warm.)

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 243 244

Sem comentários

DOD SR400D Especificações Página 151